Yealink RoomPanel Mode D'emploi page 10

E
5
N
Remove the RoomPanel
G
1. If the security latch has not be installed you can directly pull the RoomPanel to disengage the mounting
L
bracket.
2. If the security latch has be installed:
I
Edition A:
S
a. Pull the RoomPanel away from the wall until it stops.
b. Use the screwdriver to rotate the latch to the open position, which retracts the security latch arms.
H
c. Pull the RoomPanel to disengage it from the mounting bracket with the arms retracted.
RoomPanel
Edition B:
Use the release key to push down on the security bracket release tabs as shown in the following while pulling
the touch screen away from the mounting bracket.
6
Set up RoomPanel
After powering on the RoomPanel, you can perform basic settings,
network configuration and system settings through the web user
interface/device:
a. The web user interface:
① (Teams/Zoom) Go to
address.
(Other version) Go to
② Open a web browser and enter the device IP address.
The default administrator username is "admin" and password is "0000".
b. The device:
(Teams/Zoom) Go to
(Other version) Go to
The default administrator password is "0000".
8
Use the screwdriver here
> Device settings > About to obtain the IP
> Status > RoomPanel to obtain the IP address.
> Device settings.
.
Mounting
Bracket