Samsung HW-Q900A Manuel De L'utilisateur page 4

03 CONNECTING THE
SOUNDBAR
Connecting Electrical Power and
Subwoofer
POWER
Rear of Subwoofer Bottom of the Soundbar Main Unit
Manually connecting the
Subwoofer
1. Turn off the Soundbar main.
2. Press and hold ID SET on the rear of the subwoofer
for at least 5 seconds.
Rear of Subwoofer
3. Press the Up button on the remote control for
5 seconds.
5 sec
4. Check if the LINK LED is solid blue (connection
complete).
• The LINK LED indicator stops blinking and glows
a solid blue when a connection is established
between the Soundbar and the Wireless
Subwoofer.
Auto EQ
AUTO EQ technology uses the subwoofer's built-in
microphone to measure the frequency response and
calibrate the BASS performance.
• You must keep the room as quiet as possible while
operating the Auto EQ tuning.
• Do not use any buttons until the Auto EQ tuning is
complete.
• During Auto EQ Tuning, there is no sound from the
Soundbar's main unit and rear speakers.
04 USING A WIRED
DIGITAL AUDIO IN (OPTICAL)
SERVICE
ID SET ID SET HDMI IN 1 HDMI 1
(WOOFER, REAR)
NETWORK
HDMI IN 2 HDMI 2
HDMI TO TV
(eARC/ARC)
NOTE
• When the TV sound is not output, press the
5 sec
"Blinking blue fast"
• The recommended cable is High Speed HDMI Cable
• When you use an optical cable and the terminals have
ID SET
Using the Q-Symphony Function
For Q-Symphony, the Soundbar syncs with a Samsung
TV to output sound through two devices for optimum
surround effect. When the Soundbar is connected, the
menu, "TV+Soundbar" appears under the Sound Output
menu of the TV.
• TV menu example: TV + [AV] Soundbar series name
NOTE
• It can operate according to the Codec supported by
• This function is supported only when the HDMI Cable
• This function is available in some Samsung TVs and
• When using Q-Symphony, you can only choose GAME
ENG - 4
CONNECTION
1
2
POWER
DIGITAL AUDIO IN (OPTICAL)
SERVICE
POWER HDMI IN 1 HDMI 1
ID SET (WOOFER, REAR) ID SET
NETWORK
HDMI IN 2 HDMI 2
HDMI TO TV
(eARC/ARC)
HDMI OUT
HDMI IN
(ARC)
Connecting using an HDMI Cable
(External Device (HDMI 1 or HDMI 2) / TV ARC)
2
OPTICAL OUT
Connecting using an Optical Cable (D.IN)
Function) button at the top of the Soundbar or the
(Source) button on the remote control to select
the "D.IN" mode. The screen displays "D.IN" and "TV
ARC" in sequence, and TV sound is played.
with Ethernet.
covers, be sure to remove the covers.
(HDMI)
TV.
or Optical Cable (not supplied) is connected.
some Soundbar models.
PRO or ADAPTIVE SOUND.
HDMI Cable
Optical Cable (not
supplied)
DIGITAL AUDIO IN
(OPTICAL)
HDMI 2
1
HDMI 1
1
HDMI TO TV
(eARC/ARC)
DIGITAL AUDIO IN
(OPTICAL)
HDMI 1
HDMI 2
(Multi