Axis P7701 Guide D'installation page 9

Page 8
Install the hardware
!
IMPORTANT! - The casing of the AXIS P7701 is not approved for outdoor use - the
product may only be installed in indoor environments.
Mount the video decoder
The video decoder is supplied with a mounting kit containing screws, plugs, and protective pads for
mounting the video decoder to a concrete wall:
1. Place the video decoder against the wall, and mark the location of the two mounting holes
(See Hardware overview, on page 4) through which the video decoder will be attached.
2. Remove the video decoder and drill the two mounting holes.
3. Punch out the four protective pads and apply them to the underside of the video decoder.
4. Insert the wall plugs into the wall, position the video decoder, and attach it to the wall using
the screws provided.
Connect the cables
1. Connect the decoder to the network using a shielded network cable.
2. Optionally connect external input/output devices, e.g. alarm devices. See Unit connectors, on
page 5 for information on the terminal connector pins.
3. Optionally connect an active speaker and/or external microphone.
4. Connect the decoder to the monitor.
5. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet, Class 2). If available, this is automatically detected when the
network cable is connected (see above).
• Connect the supplied indoor power supply to the power connector on the decoder.
6. Check that the indicator LEDs indicate the correct conditions. See the table in LED indicators, on
page 7 for further details.
AXIS P7701 Installation Guide