Introduction; Device Description; Scope Of Delivery - Scheppach UMF1550 Traduction Des Instructions D'origine

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
we hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the device and take ad-
vantage of its application possibilities in accordance
with the recommendations.
The operating instructions contain important informa-
tion on how to operate the device safely, profession-
ally and economically, how to avoid danger, costly
repairs, reduce downtimes and how to increase reli-
ability and service life of the machine.
In addition to the safety instructions in these oper-
ating instructions and the safety instructions for the
machine mounted, you must also observe your coun-
try's regulations applicable to the operation of this
device and the electric power tool mounted.
Keep the operating instructions package with the
device at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the device and
carefully follow its information.
The device can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated
dangers.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
m Attention!
The electric power tool mounted on the universal
machine stand may only be used by personnel who
have been trained in the use of the electric power
tool and who have been instructed with respect to the
associated hazards.
The minimum age requirement must be complied
with.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to
the operation of such devices must also be observed.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

2. Device description

A. Universal machine stand
B. Support arm
C. Crossbar
D. Adjustable workpiece support
E. Screw
F. Washer
G. Spring washer
H. Nut
I. Star-grip screw
J. Star-grip screw
3. Scope of delivery (fig. 2)
• 1x Universal machine stand (A)
• 2x Support arm (B)
• 2x Crossbar (C)
• 2x Adjustable workpiece support (D)
• 4x Screw (E)
• 4x Washer (F)
• 4x Spring washer (G)
• 4x Nut (H)
• 4x Star-grip screw (I,J)
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
GB | 11