Preparation - LF Kobalt TQ3126 Manuel

paCkaGe ContentS
part DeSCription
D Check Valve - one-way valve that allows air to enter the tank, but prevents air in the
tank from flowing back into the compressor pump.
E belt Guard - Covers the belt, motor pulley and flywheel.
F Side Drain Valve - Use this valve to drain moisture from the tank daily to reduce the
risk of corrosion.
G bottom Drain Valve - Use this valve to drain moisture from the tank daily to reduce
the risk of corrosion.
H tank pressure Gauge - Indicates amount of air pressure stored in tank.
I air filter - Keeps large particulates out of the air flowing into the compressor.

preparation

Before beginning installation and/or assembly of product, make sure all parts are present. Compare
parts with package contents list. If any part is missing or damaged, do not attempt to assemble or use
the product. Contact customer service for replacement parts and assistance.
WarninG
risk of personal injury. Do not operate unit
if damaged during shipping, handling or use.
Damage may result in bursting and cause
injury or property damage.
estimated installation and assembly time: 120 minutes
Tools Required for Installation and Assembly (not included): Safety Glasses; Work Gloves; 9/16 inch
Socket and Ratchet; Tape measure; Hammer Drill and Masonry Bit; Hammer; Phillips Screwdriver;
Flathead Screwdriver; Pipe Wrench; Two Adjustable Wrenches; 1/4 inch Nut Driver, Socket or Wrench;
240 Volt, Double Pole Circuit Breaker; Voltage Meter
ADDITIoNAL PARTS REQUIRED FoR INSTALLING [not included]
Parts (part number) - available at 1-888-3KoBALT (1-888-356-2258) or local hardware store.
1. Vibration Pads (PA300600AV)
2. 3/8 inch x 5 inch Wedge Anchors for Concrete (Standard Hardware Item)
3. 240 Volt / 30 Amp double pole breaker (Standard Hardware Item)
This unit requires a dedicated 220 Volt - 240 Volt / 30 Amp circuit with a double pole breaker.
7
Qty.
1
1
1
1
1
2