DWT KF06-30 Notice Originale page 23

General operational
fig. 9-10)
• Mark out and fix the treated workpiece.
• Set the required milling depth, as described above�
• When using the guide 9 or the parallel guide 13,
adjust them as described above�
• Turn on the power tool�
• Mill with uniform flow holding the power tool firmly
and following recommendations regarding the direction
of milling� Do not push excessively - it takes some time
to complete the process� Excessive force will not speed
up the work process, but it will overload the power tool�
• Turn the power tool off�
Guide with a roller (see fig. 9)
The guide 9 is used for milling edges with milling cutters
which do not have support bearings at the end� Milling
along the curved side surface is allowed (see fig. 9.2).
• Set the guide 9 and adjust its position as described
above�
• Mill by pressing the roller 23 against the side surface
of the workpiece (see fig. 9.2).
Parallel guide (see fig. 10)
Parallel guide 13 enables milling along the straight line
side surface of the workpiece�
• Set the space from the work piece brim by adjusting
the parallel guide 13, as described above�
• Perform the milling operation by pressing parallel
guide 13 to the side surface of the workpiece (see fig. 10.2).
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
The manufacturer reserves the possibility to introduce changes.
recommendations (see Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 1�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
23
Transportation
of the power tools
Environmental
protection