Figure 7. Removing The Pool And Spa White Light Assembly For Lamp Replacement; Figure 8. Alignment Of The Lens, Face Ring - Jandy Pro Series WPLV100WS30 Guide D'installation

PAGE 12
ENGLISH
POOL WHITE LIGHT
ASSEMBLY
Power
Niche
Cord
Bonding
cable
POSITIONING TAB
TAB LOCATOR

Figure 7. Removing the Pool and Spa White Light Assembly for Lamp Replacement

5. Reassemble the fixture as follows:
a. If not already done, remove the gasket from
the glass lens and install a new gasket, Jandy
Pro Series Pool Light Gasket (P/N R0451101)
and Jandy Pro Series Spa Light Gasket (P/N
R0400501), on the lens.
NOTE A new lens gasket must be used each
time the light is reassembled.
b. While holding the fixture upright, place the glass
lens with the gasket on top of the fixture. Please
note that the lens gasket is not symmetrical.
Therefore, it must be installed correctly so that
the lens can seal to the fixture housing. Place the
gasket on the lens so that the thick molded side
of the gasket will mate with the housing when the
lens is installed. See Figure 11.
Figure 8. Alignment of the Lens, Face Ring, Housing and Clamps for Pool White Lights
Jandy Pro Series Underwater Pool and Spa White Lights | Installation Manual
®
POOL WALL
Unscrew pilot screw
1
and pull top of light
assembly away from
pool wall
PILOT SCREW
2 Push up on
bottom of
light assembly
Align arrow of the lens
with pilot screw
SPA WHITE LIGHT
ASSEMBLY
Power
Niche
Cord
Bonding
cable
POSITIONING TAB
TAB LOCATOR
c. Position the lens and gasket on the fixture. Place
the face ring and the top clamp over the lens and
align the pilot screw with the small arrow mark
on the face of the lens. Note that the small arrow
mark on the face of the lens and the pilot screw
of the face ring must be aligned with the arrow
located on fixture label that reads, "Arrow on this
label must line up with the pilot screw on the Face
Ring". See Figure 8.
d. While holding the aligned face ring assembly and
fixture together, turn the assembly upside down
and set it on the old gasket, using the old gasket
as an assembly fixture. This will keep the lens and
gasket assembly from being pushed out of the face
ring while you secure it to the light fixture.
e. Spread the bottom clamp over the electrical cord
and slide it onto the back of fixture to the top
clamp. See Figure 8.
Align pilot screw with arrow
located on fixture label
SPA WALL
Unscrew pilot screw
1
and pull top of light
assembly away from
spa wall
PILOT SCREW
2
Push up on
bottom of
light assembly