Functional Description - Makita AT1150A Manuel D'instruction

FUNCTIONAL
DESCRIPTION
CAUTION:
• Always disconnect the hose before adjusting or
checking function on the tool.
Adjusting depth of stapling
1
► 1. Depth adjusting plate 2. Hex wrench
To adjust the depth of stapling, loosen the bolt by using
the hex wrench provided with the tool and then slide the
depth adjusting plate up or down.
If staples cannot be driven deep enough, slide the
adjusting plate in the direction of arrow as shown in the
figure.
If the staples are driven too deep, slide the adjustinhg
plate in the direction of arrow as shown in the figure.
2
5 ENGLISH
The depth can be adjusted 5 mm to the maximum.
Tighten the bolt securely at the right position after
adjusting.
ASSEMBLY
CAUTION:
• Always disconnect the hose before carrying out
any work on the tool.
Hook
► 1. Hook 2. Screw
CAUTION:
• Always disconnect the hose from the tool.
• Never hook the tool at high location or on poten-
tially unstable surface.
The hook is convenient for hanging the tool temporarily.
Secure the hook on the tool with the provided screw
using either of two holes in the hook as shown in the
figure.
Loading stapler
CAUTION:
• Always disconnect the hose before loading the
tool.
• Do not use deformed staples or staple strip.
Failure to do so causes poor staple feeding.
• Always use staples specified in this instruction
manual. Failure to do so causes poor staple
feeding.
• Always return the pusher slowly and gently
while holding it with a hand.
Select staples suitable for your work. Make sure that the
hose is disconnected from the tool.
1. Pull the pusher to the rear of magazine and hook
the groove in the pusher on the lock pin.
1
2