Samsung HT-F6530 Mode D'emploi page 15

Installing the Speakers on the Tallboy Stand
1. Turn the Stand Base upside-down and connect it to
the Stand.
2. Use the driver to combine the screws (5x20) on the
3 marked holes.
3. Straighten a supplied speaker wire and put in the
hole on the center of Stand Base.
4. Connect the upper Speaker to the assembled
Stand.
5. Insert a screw (5x15) clockwise into the hole on the
rear of the speaker using a screwdriver.
And then connect a speaker cable.
6. This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
Connecting The Speakers
1. Match each speaker cable bundle to the correct speaker by matching the color
coded plug on each bundle to the colored sticker on the bottom of each speaker.
2. To attach speaker wire to each speaker:
a. Press down the red tab on the back of the speaker, insert the red wire, and then
release the tab.
b. Press down the black tab on the back of the speaker, insert the black wire, and
then release the tab.
3. Connect the speaker wire plugs from each speaker to the back of the product by
matching the colors of the speaker plugs to the colors of the speaker jacks.
1
Stand Base
Stand
3
5
2
4
Speaker
Stand
6
Black Red
15
|
English