Start-Up; Charging The Rechargeable Battery; Inserting And Pulling Out The Re- Chargeable Battery (05); Operation - AL-KO MB 2010 Manuel D'utilisation

GB

5 START-UP

5.1

Charging the rechargeable battery

CAUTION!
Danger of fire during charging!
Due to heating of the charger, there is a
danger of fire if it is placed on an inflam-
mable surface and is not adequately
ventilated.
■
Always use the charger on a non-in-
flammable surface or in a non-com-
bustible environment.
■
If available: Keep the ventilation
slots free.
NOTE
The rechargeable battery and the
charging unit are not included.
The rechargeable battery is partially charged.
Fully charge the rechargeable battery before us-
ing it for the first time. The rechargeable battery
can be charged in any charge status. Interrupting
charging does not damage the rechargeable bat-
tery.
NOTE
For detailed information, heed the sepa-
rate operating instructions for the re-
chargeable battery and for the charging
unit.
See:
■
Operating instructions for lithium-ion re-
chargeable battery - B50 Li
■
Operating instructions for charging unit – C30
Li
5.2 Inserting and pulling out the
rechargeable battery (05)
Inserting the rechargeable battery (05/a)
1. Push the rechargeable battery (05/1) into the
rechargeable battery slot (05/2) until it engag-
es.
Pulling out the rechargeable battery (05/b)
1. Press and hold the unlock button (05/3) on
the rechargeable battery.
2. Pull out the rechargeable battery.
28

6 OPERATION

6.1

Adjusting telescopic handle (06)

1. Turn upper locking sleeve (06/1) approxi-
mately 180° in the direction of the arrow (06/
a) to release.
2. Adjust telescopic handle (06/2) individually to
a comfortable height. The telescopic handle
can be extended by approx. 10 cm (06/b).
3. Screw locking sleeve tight (06/c).
6.2

Swivelling brush head (07)

The brush head can be swivelled to four posi-
tions, 0°, 18°, 36° and 54°, to make working easi-
er.
1. Press (07/a) locking button (07/1).
2. Set (07/b) the brush head (07/2) to the de-
sired position.
3. Release the locking button.
6.3 Switching the patio cleaner on and off
(10)
1. Stand securely.
2. Hold the appliance with both hands. Do not
rest the brush head on the ground when do-
ing this.
3. Grip the guide handle (01/4) with one hand
and the handle of the basic appliance (01/1)
with the other.
4. Press the safety button (10/1).
5. Press the on/off switch (10/2) and hold. The
tool starts. Release the safety button.
6. The appliance switches off when the ON/OFF
switch (10/2) is released.
7 WORKING BEHAVIOUR AND
WORKING TECHNIQUE (08)
■
Switch the appliance on before approaching
the surface to be cleaned, and only lower it
then to avoid overloading.
■
Position the appliance with the guide wheel
(08/1) first to clean the surfaces with the
brush (08/2). Walk forwards slowly (08/a).
■
Do not swivel the appliance to the left and
right when working.
■
Severe dirt must be cleaned in layers. Always
proceed in the same direction (08/a).
■
If the appliance is overloaded by pressing on
too hard, the brush is blocked. Immediately
lift the appliance so it releases. Otherwise,
the motor could be permanently damaged.
Start-up
MB 2010