Setting "Dual Sensor" Parameter; Setting "Sensor Led" Parameter - Waldmann POWER III Mode D'utilisation

ENG
6.9 Setting "Dual sensor"
parameter
This parameter allows you to have the con-
trol evaluate an external sensor signal if a
suitable communication module has been
built into the luminaire, such as a TALK
module.
If the parameter is ON, the control will eval-
uate an external and its own sensor signals.
If the parameter is OFF , the control will not
evaluate any external sensor signals.
Factory setting: As-delivered, the param-
eter is OFF.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first and second LEDs on the light
bar are lit.
X Press the lower key twice.
The third LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
28
Parameter setting | Explained step by step
6.10 Setting "Sensor LED"
parameter
This parameter allows you to switch the
LEDs on the sensors on and off.
If the parameter is ON and the luminaire is
on, the LEDs on the sensors will be lit, see
chapter "LEDs in the sensors" , page 20.
If the parameter is OFF , the LEDs on the
sensors will not be lit.
Factory setting: As-delivered, the param-
eter is OFF.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first and second LEDs on the light
bar are lit.
X Press the lower key three times.
The fourth LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.