Description of the Appliance
Illustrations on fold-out page!
These operating instructions describe the
multi-purpose vacuum cleaner shown on
the cover page.
When unpacking the product, make sure that no acces-
sories are missing and that none of the package con-
tents have been damaged. If you detect any transport
damages please contact your dealer.
Suction hose connection
Illustration
To connect the suction hose during vacuuming.
ON/OFF switch for appliance
Illustration
Position I: Suction or blowing
Position 0: Appliance is switched off
Carrying handle
To carry the appliance or to remove the appliance
head after unlocking.
Cable hook
Illustration
To store the mains cable.
Blowing connection
Illustration
Connect the suction hose to the blower connection,
this will activate the blower function.
Container closure
Illustration
Pull out to open, push in to lock.
Parking position
Illustration
To rest the floor nozzle during work interruptions.
Accessory mount
Illustration
The accessories compartment allows the storage
of suction pipes and suction nozzles on the appli-
ance.
Steering roller
Illustration
The steering rollers are located in the compartment
when the appliance is delivered. These must be at-
tached prior to starting up the appliance.
Filter bag
Note: Do not use a filter bag for wet vacuuming!
Illustration
Recommendation: To vacuum fine dust, use the
filter bag.
Cartridge filter
Illustration
The cartridge filter must always be installed - with
wet and dry vacuuming.
Note: Let the wet cartridge filter dry prior to using it for
dry vacuuming.
Suction hose with connecting piece
Illustration
Push the suction hose into the connection on the
appliance, it snaps in place.
In order to disconnect it, push down with your
thumb and pull the suction hose out.
Note: Accessories, such as suction brushes, can be di-
rectly attached to the connecting piece and thus con-
nected to the suction hose.
For convenient working even in tight spaces.
See position 13.
The removable handle can be attached between the ac-
cessories and the suction hose if necessary.
Recommendation: In order to vacuum the floor, attach
the handle to the suction hose.
Removable handle
Illustration
Connect the handle with the suction hose until it
snaps in place.
Illustration
To remove the handle from the suction hose, press
the notch using your thumb and pull off the handle.
Note: Due to removing the handle, accessories can be
directly attached to the suction hose.
Recommendation: In order to vacuum the floor, attach
the handle to the suction hose.
See position 12.
Suction tubes 2 x 0.5 m
Illustration
Put both suction tubes together and connect them
with the handle.
Crevice nozzle
For edges, joints, heaters and hard to reach loca-
tions.
Floor nozzle
(with switching lever)
Illustration
For convenient switching between dry and wet dirt:
For vacuuming dry dirt off the floor, use position
with extended brush strips.
For vacuuming water off the floor, use position with
extended rubber lips.
8
EN
13