Batavus E-go E Serie Guide D'utilisation page 34

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

• A full charge will take approximately 4.5 – 7.5 hours. This will be
dependent on your battery pack.
• With models equipped with a removable battery pack, the battery
pack can be charged both in and outside the bicycle.
• When placing back, ensure that the contact points of the battery
pack meet those of the docking station (E).
Advice for charging
Before using the bike for the first time, charge the battery pack
completely until the indicator lamp on the charger turns green.
The indicator lamp glows red while the battery is still charging.
Always charge the battery pack using the charger supplied with the bike.
Never use another charger.
When the battery pack is fully charged, charging will stop automatically
after 24 hours. The small lamp on the charger will continue to glow
green. Connect the charger to the mains again each time you charge to
ensure that the charging process starts immediately. The charger does
not automatically switch on unless it is reconnected to the mains power
supply.
A battery pack can become defective if it is emptied and not recharged.
The warranty on the battery pack will be invalidated if a deep discharge
is detected.
In the event of long-term stalling: Charge the battery pack fully and
disconnect the charger from the battery pack. Charge the battery
pack at least once every two months. You can also leave the battery
pack connected to the charger if you wish. If you do that, disconnect
the charger once every two months and reconnect it to make sure the
charging process is started again.
The battery pack will not charge if the temperature is lower than about
0 ºC or above about 45 ºC. This prolongs the service life and improves
the performance of the battery pack.
34
34

Publicité

Table des Matières
loading

Table des Matières