Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LVLD3
8
Adjust Temperature with Water Running
This valve is NOT factory preset.
Upon installation, the temperature
of this valve must be checked and
adjusted to ensure delivery of a
safe water temperature. Water
in excess of 110°F (43°C) may
cause scalding.
9
Trap Cover
Make all connections before installing trap cover.
Hang the trap cover onto
the hook, then secure the
A
trap cover with the screws
provided, starting with the
side screws.
12
Loosen Cap Screw about 1/4" (4-6
A
turns) and lift up cover (do not
remove).
Using cover, turn cartridge gently until
B
desired water temperature is reached.
Do not turn past stops as this may
damage unit. Push cover down and
tighten screw.
6/3/2016
Hook
Washer
#10-24
Screw
Finishing
Washer
Bradley • 215-1779 Rev. E; ECN 16-08-008
Installation
C
H
#10-24
Flat Head
Screw
Publicité
Table des Matières
