Klarstein ICEFESTIVAL CUBE Mode D'emploi page 19

EN
Note: The maximum permissible inlet water pressure: 0.6MPa. The minimum permissible
inlet water pressure: 0.14MPa.
Step 2
Connect to the power
Step 3
Press ON/OFF button to turn unit on. The ice maker begins to work.
Note: For the first three cycles, the ice may be small and irregular in size, or even no ice.
Step 4
If indicator ADD WATER lights up, please take out the basket, then add water as per
step 1.
Step 5
If indicator ICE FULL lights up, please take out the ice with the scoop.
Note: When the ice basket is full please remove the ice immediately, Do not allow the
ice collecting tray overfill.
Step 6
Press SHAVED ICE button to shave ice.
Note: Before the press of this button, please put enough ice into the shaved ice bowl
and cover the bowl cap well.
Step 7
Press ON/OFF button to stop the machine.
Step 8
Put a tank in below the unit, then pull the unit a little forward, pull the drain plug at
middle of the tank to drain water.
19