Philips QT4045 Mode D'emploi page 12

ENGLISH
12
Troubleshooting
The trimmer does not work when it is switched on.
1 If the battery is completely empty, the trimmer will not work.
Charge the appliance until it is fully charged (see chapter
'Charging'). Charging will take approx. 10 hours.
If the suction system of the vacuum beard trimmer performs poorly or
does not work at all, check the points listed below.
2 Is the hair-collection chamber empty?
We advise you to empty the hair-collection chamber after each
B
trimming session. When cutting long, dense beards, it may also be
necessary to empty the hair-collection chamber during the trimming
session.
3 Is the hair-collection chamber or the filter wet?
Both parts may only be cleaned dry. If these parts become wet, dry
B
them carefully.
4 Does the flexible hair guide in front of the cutting unit jam?
The transparent hair guide needs to be flexible in order to be able to
B
adjust to the contours of the face. If it jams because hairs have got
stuck in it, remove the hairs carefully with the brush supplied. The
flexible hair guide should yield at the touch of a finger.
5 Do you move the appliance in the optimal direction? (fig. 5).
For the best possible trimming and suction performance, we advise you
B
to move the trimmer upwards, against the direction of hair growth,
making smooth and gentle strokes.