Wittkopp Basic Manuel D'utilisation page 16

3. Opening delay and opening window
The opening delay can be 1 to 99 minutes:
This the waiting time before you can open the lock.
The opening window time can be 1 to 19 minutes:
You have to enter the code again to open the safe during this window (the period in which you can open it).
3.1 Programming the opening delay and opening window
Make sure that the safe door is open while you change the opening delay and window (key in the master code).
Step
1. Press and hold the '9' button until the red light stays on
2. Key in the master code, for example 567891
3. Enter the opening delay using two digits, for example 5 minutes
Enter the opening window using two digits, for example
4.
1 minute
5. Repeat the opening delay time
Repeat the opening window time
6.
(the red light goes out)
If the red light goes out during programming, you have waited too long to make an entry. In that case, start again
at step 1.
3.2 Opening with opening delay and opening window
Step
Enter the user or master code, for example 567891
1.
The opening delay time starts, the red light illuminates every
2.
few seconds
When the opening delay has elapsed, you will hear an audible
signal and the opening window begins. The light illuminates
3.
every few seconds.
Enter the user or master code, for example 567891
4.
Open the handgrip within 3 seconds, and the safe is open
5.
16
Key in code - start opening delay
Waiting time opening delay
Opening window - re-enter your code
Action
Action
Key
9
567981
05
01
05
01
Key
567891
567891