Olympus CAMEDIA E-10 Manuel De Base page 13

Masquer les pouces Voir aussi pour CAMEDIA E-10:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Switching the Camera On/Off
To switch the camera on or off, move the power
switch to ON or OFF. When the camera is in the
shooting mode (mode dial set to P, A, S or M),
if it remains idle for a specified length of time it
will switch off the displays automatically and
enter the sleep mode to conserve battery
power. To restore the camera to full operation,
press any button on the camera. If the camera
remains idle for one hour after entering the
sleep mode, the camera will shut itself off
completely. In order to restore full operation,
switch the camera off and switch it on again.
The first time that you switch the camera on,
you should set the date and time.
Checking the Number of Storable Pictures
The large two-digit number in the lower right
section of the control panel displays the
number of storable images. When this number
reaches zero, replace the card or if you have
two cards installed in the camera, select the
other card. The number of images that you can
store on a card is determined by the size of the
images. The size of the image is determined by
the record mode settings (quality, resolution,
compression) that you select in the shooting
mode. The available qualilty selections are
TIFF, SHQ, HQ (default), and SQ (Tagged
Image File Format, Super High Quality, High
Quality, Standard Quallity).
Memory card storage capacity
Quality
Resolution (pixels)
(Default settings)
TIFF
2240 x 1680 (FULL)
SHQ
2240 x 1680 (FULL)
HQ
2240 x 1680 (FULL)
SQ
1280 x 960 (SXGA)
Checking the Battery
The battery check mark (shaped like an AA
(R6) battery) in the control panel indicates
battery performance. When the camera is
switched on, if the battery check appears full
and goes off this means the batteries are fully
charged. If the battery check mark appears
partially filled and continues blinking, the
batteries are low and should be replaced as
soon as possible. If the battery check mark
partially filled goes off and the control panel
extinguishes completely, this means the
batteries are fully discharged and you cannot
continue shooting pictures until you have
replaced the batteries.
Selected card
Compression
File Size
(Default settings)
(Reference value)
1:1
11.3 MB
1:2.7
2.8 MB
1:8
950 KB
1:8
300 KB
Number of storable pictures
Images per Card
(Reference value)
8 MB
32 MB
0 shots
2 shots
2 shots
11 shots
8 shots
34 shots
27 shots
110 shots
13

Publicité

Table des Matières
loading

Table des Matières