Replacing The Shaving Foil; Replacing The Cutter Blocks - Medion MD 16623 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

9.1. Replacing the shaving foil

 Switch off the appliance, pull the mains adapter from the socket and the
connector plug from the appliance (if applicable).
 Press the release buttons and remove the shaving foil.
 Pull the shaving foil out of the housing by holding the tabs for the
release buttons.
 Insert the new shaving foil into the housing until it clicks audibly into
place.
 Replace the cutter blocks as described below.

9.2. Replacing the cutter blocks

 Take hold of the cutter blocks on the sides and remove them by
pulling them upwards.
 Then insert the new cutter blocks into the relevant holder and press
them down carefully until they click audibly into place.
 Press the shaving foil gently onto the appliance until it clicks audibly
into place.
124 of 134

Publicité

Table des Matières
loading

Table des Matières