Fellowes LX Serie Mode D'emploi page 2

LX /LX
A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, plastic credit cards, staples and paper clips
Will not shred: Adhesive labels, continuous form paper,
transparencies, newspaper, cardboard, CD/DVDs, laminates,
file folders, X-rays or plastic other than noted above
* A4 (70g), paper at 220V-240V, 50/60 Hz, 2.5 Amps (LX200), 4.5 Amps (LX210), 5.0 Amps (LX220); heavier paper, humidity or other than rated voltage may
reduce capacity. Maximum recommended daily usage rates: 1000 sheets per day, 25 credit cards. Fellowes SafeSense
operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
WARNING! IMPORTANT SAFETY INSTRUCTIONS – Read before using!
are covered in the instruction manual. Read the entire
instruction manual before operating shredders.
from paper entry. Always set to off or unplug when
not in use.
top opening, switch to Reverse (
aerosol lubricants on or near shredder. DO NOT USE
"CANNED AIR" OR "AIR DUSTERS" ON SHREDDER.
Vapors from propellants and petroleum based
disassemble shredder. Do not place near or over heat
source or water.
BASIC SHREDDING OPERATION
LX200
Continuous operation. Up to 10-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 10-minutes will trigger
15-minute cool down period.
LX210
Continuous operation. Up to 20-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 20-minutes will trigger
15-minute cool down period.
LX220
Continuous operation. Up to 30-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 30-minutes will trigger
15-minute cool down period.
2
LX
F.
A.
B.
G.
C.
D.
E.
) to back out
F.
A. SafeSense
G.
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
1. OFF
2. ON
G. Control Panel and LEDs
Paper shred size: Mini-Cut, 4mm x 12mm
Maximum Sheets per pass:
LX200 - 12*, LX210 - 16*, LX220 - 20*
Maximum Paper entry width: 230mm
(F) that must be in the ON ( ) position to operate
shredder. In case of emergency, move switch to
OFF (O) position. This action will stop shredder
immediately.
shredder head.
grounded wall outlet or socket of the voltage
and amperage designated on the label. The
grounded outlet or socket must be installed near
converters, transformers, or extension cords should
not be used with this product.
sound chips or batteries.
PAPER OR CARD
1
Plug in and put disconnect power
switch in ON (I) position
2
Align paper/card to center of paper
entry. Feed straight into paper entry
and release.
ENGLISH
Technology
®
shredders are designed to be
®