Starting Up First Time - Teuco CHEERS CH4 Manuel De Mode D'emploi

EN

STARTING UP FIRST TIME

1 - REMOVE THE THERMAL CANVAS FROM THE MINIPOOL
See "Minipool thermal canvas".
2 - RIEMPIRE LA MINIPISCINA
Fill the minipool until water is 2 cm. above the highest spa jet.
The water filling the tub must not exceed 35°C.
When filling the Teuco minipool, use an external hose, taking care
not to immerse it in the water as this could cause the water to flow
back into the mains system.
3 - SWITCH ON THE ELECTRICAL SYSTEM
ATTENTION: Switch on the electrical system AFTER having
filled the minipool with water.
The main selector switch that was installed during the installation
phase of the minipool must be turned to the "ON" position.
Check that the circuit breaker switch installed during the pre-instal-
lation operates correctly by pressing the test button which should
intervene on the circuit.
Reset the switch after testing it.
Refer to first starting phase as shown on the instruction manual
"Control panel".
ATTENTION: Sometimes the unit does not switch on if air
has accumulated in it. To release the air from the system,
slacken the ring of the pump until the hydromassage or the
recirculation system switches on, then retighten the ring.
6