Starting Up First Time - Teuco 641 HR Manuel De L'utilisateur

EN
F - Roto Stream Jet:
G - Refrigerated compartment: A built-in refrigerated compartment to allow you to enjoy cool
H - Control panel:
I - Chromoexperience:
L - Suction openings:

STARTING UP FIRST TIME

1 - REMOVE THE CANVAS FROM THE MINIPOOL
See "Minipool Canvas".
2 - FILL THE MINIPOOL
Fill the minipool until the skimmer rises (refer to the
"WATER LEVEL" label).
The water put into the pool must be no hotter
When filling the Teuco minipool, use an external hose,
taking care not to immerse it in the water as this could
cause the water to flow back into the mains system.
3 - SWITCH ON THE ELECTRICAL SYSTEM
ATTENTION: Switch on the electrical system AFTER
having filled the minipool with water.
The main selector switch that was installed during the installa-
tion phase of the minipool must be turned to the "ON" position.
Check that the circuit breaker switch installed during the
pre-installation operates correctly by pressing the test but-
ton which should intervene on the circuit.
Reset the switch after testing it.
The recirculation pump automatically switches on.
Switch on the hydromassage unit by pressing the "Pump"
key on the control panel.
Open all the jets and check that there is no water leaking
from the hydraulic connections and that everything is
working correctly and then switch off the pump.
6
These add to the characteristics of stream jets with the
effectiveness of a rotary jet that, thanks to its rotating movement,
increases the range of action of each single jet. Perfect for
relieving the muscles in the back, shoulders and neck
drinks any time.
Compartment containing a touch control panel.
Even in the evening, your Teuco Minipool will be spectacular to
look at, with the chromoexperience that creates colourful lighting
effects, designing fascinating contrasts on the surface of the
water.
These openings suck in the water to take it into the spa massage
system.
than 35 °C.
641 HR-HS