Installation; Installation Site (Qualified Specialist); Outdoor Installation; Installation Position - BADU Jet Wave Traduction Du Instruction D'utilisation Originale

Installation

5 Installation
5.1

Installation site (Qualified specialist)

5.1.1

Outdoor installation

 In order to increase the pump's service life, provide simple
weather protection.
5.1.2

Installation position

 The unit is normally installed on the narrow side of the pool
with a recommended minimum pool length of 4 m.
 From a pool width of 4 m, installation on the longer side is
also possible.
 For round and oval pools made from smooth sheet steel or
plastic, a minimum radius of 2 m is required.
 For round and oval pools made from made from stone or
concrete, a flat surface with a minimum width of 480 mm is
required.
 The water depth at the position of installation should be
between 1.2 m and 1.5 m. Thus the massage hose can be
used appropriately and optimally.
5.1.3

There must be ground drainage

 Calculate the size of the ground drain according to the
following criteria:
• Size of the swimming pool.
• Circulation flow rate.
5.1.4

Ventilation and aeration

 Ensure sufficient ventilation and aeration. The ventilation and
aeration must ensure the following conditions:
• Prevention of condensation.
• Minimum distance from fan cover to the wall: 120 mm.
• Cooling of the pump motor and other system components,
for example switch cabinets and control units.
• Limitation of the ambient temperature to maximum 40 °C.
5.1.5

Structure-borne and airborne noise transmission

 Observe regulations for structural noise protection, for
example DIN 4109.
 Install the pump in a manner which reduces structure-borne
and airborne noise transmission. Vibration-absorbing
materials are suitable bases. Examples:
• Anti-vibration buffers
• Cork lining
• Sufficiently hard foam
18 EN 08|2020