Publicité
Les langues disponibles
Les langues disponibles
the receptacle end of the extension cord has large and small blade
slot widths. If the plug does not fit fully into the extension cord,
reverse the plug. If it still does not fit, obtain a suitable extension
cord. If the extension cord does not fit fully into the outlet, contact
a qualified electrician to install the proper outlet. Do not change the
tool plug or extension cord in any way.
SAVE THESE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
ATTACHING THE GUARD, HANDLE AND EDGE GUIDE TO THE
TRIMMER/EDGER
WARNING:
The guard and handle must always be on the
tool to protect the user. NEVER OPERATE TOOL WITHOUT
GUARD AND HANDLE FIRMLY IN PLACE.
Unplug the tool before attempting any of the following assembly steps.
1. Locate the edge guide and spread it apart as shown in figure 1.
2. Attach the edge guide to the housing by locating the two ends into
the holes in the housing.
3. See figure 1A for edge guide assembled on the trimmer.
DO NOT INSERT THE ENDS OF THE EDGE GUIDE INTO THE
FAN HOLES AS SHOWN IN FIGURE 1B.
1
1A
1B
The handle is shipped with the screw partially threaded in to prevent
loss.
To attach the handle:
1. Remove the screw.
2. Slide the handle onto the handle
housing as shown in figure 2.
3. Thread the screw back into the
hole and tighten securely with a
screwdriver.
• Remove the guard attachment
screw from the guard. Slip the
guard onto the trimmer housing
and lineup the screw hole in the
guard with the screw hole in the
housing (figure 3).
• Insert the guard attachment screw
to secure the guard in place as
shown in figure 4.
4
2
3
4
Publicité
