Westinghouse W-490 Guide D'utilisation

Owner's Manual
LED Indoor Lighting Fixture
Installation Instructions
WARRANTY INFORMATION
This Westinghouse Lighting Fixture is warranted against defects in material and workmanship for a
period of Five Years from purchase date. This warranty is in lieu of all other warranties expressed or
implied.
This warranty does not cover acts of nature such as lightning damage, or corrosion and discoloration of
components, nor does it cover damages caused through abuse, improper installation, surges in electric
current, or acts of third parties.
This warranty does not cover costs of removing and re-installing the lighting fixture.
If this product fails for any reason covered by this warranty, contact us toll free at 1-888-417-6222.
ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE
Congratulations on your Westinghouse purchase. This fixture has been designed to give you many
years of beauty and service. For questions and comments, please visit
www.westinghouselighting.com/contact-us.
NOTE: Carefully unpack fixture and parts. Make sure all parts are included before discarding any
packing materials.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
1. Read all instructions carefully before installation and operation.
2. If you are not familiar with state and local electrical codes, it is recommended that you consult with
a qualified electrician.
3. Do not use in wet locations, use indoors only.
4. Non-replaceable LEDs.
5. Caution: LEDs emit bright light. Avoid looking directly into the light source for prolonged periods to
avoid eye damage.
6. Not to be used with a dimming circuit or any other electronically controlled switch.
INSTALLATION STEPS
1. Select suitable location that can support the weight of
the fixture and has an outlet on the ceiling to ensure
that the fixture hangs properly. Determine method of
mounting before drilling. Mark two spots on the
ceiling 32.75 inch apart for the mounting hardware
(not included). (Fig. 1)
2. For Mounting to Drywall:
Drill 1/4 in. holes into the ceiling to clear the closed
flaps of the toggle bolt. Make sure to fasten the toggle
bolt into the butterfly nut before inserting the flaps
into the ceiling with the toggle bolt protruding
through the ceiling. Lock the assembly by screwing
the hook into the ceiling. (Fig. 2)
W-490
092816
32.75 inch
Fig. 1
Drywall
Fig. 2
For Mounting to Wood:
Drill 1/16 in. diameter pilot hole in the ceiling. Make
sure to fasten the combo wood-machine end into the
metal hook. Screw into ceiling to lock and tighten.
(Fig. 3)
3. Install coil chain (A) onto ring hook at each end of
fixture. (Fig. 4)
4. Hang fixture body by placing one coil chain (A) over
each hook that has been installed in the ceiling. You
may need to adjust the chains slightly on the hooks
for fixture to hang level. Fixture must hang at least
7.5cm (3 in.) from ceiling. (Fig. 5)
5. Insert powercord into ceiling duplex receptacle.
Lengthen the pull chain (B), if necessary. (Fig. 6)
CLEANING AND CARE
To clean, wipe fixture with soft cloth. Clean glass with mild soap. Spray from chemical cleaners can
discolor the finish of fixture. Do not use scouring pads, powders, steel wool or abrasive paper to clean
this fixture.
NOTE FOR FIXTURES THAT ARE SOLID BRASS:
Your hand-crafted, solid brass lighting fixture has been coated with a durable, baked-on acrylic lacquer
which gives maximum protection against the weather. However, in time the brightness of the brass
will tarnish, giving way to an authentic old-world brass finish. To keep your solid brass fixture looking
new for years to come, regularly apply a good quality, non-abrasive car wax to all metal surfaces,
giving the fixture an extra protective covering.
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting.
Wood
Fig. 3
Coil Chain (A)
Ring Hook
Fixture
Fig. 4
Coil Chain (A)
Fig. 5
Powercord
Pull Chain (B)
Fig. 6
www.westinghouselighting.com
All rights reserved. Made in China
Fixture