Operating Instructions - Deltran Battery Tender 030-1011-CA Manuel D'instructions

OPERATING INSTRUCTIONS

VEHICLE JUMP STARTER & PORTABLE POWER BANK FEATURES
7
JUMP STARTING A VEHICLE
1) Before jump starting your particular vehicle always check the manufacturer
instructions/recommendations/warnings first.
2) Check the battery level of the Vehicle Jump Pack by pressing the ON/OFF
button before jump starting your vehicle. There must be at least 50% of
battery level available.
3) Insert the smart alligator clip connector into the end of the Jump Pack.
4) Connect the RED positive clip to the positive post on the battery, then the
BLACK negative clip to the negative post on the battery.
5) CAUTION: Ensure the Vehicle Jump Pack and smart alligator clip cables are
clear of all vehicle fan blades/belts/pulleys etc. before proceeding.
6) The LED on the smart alligator clips will then turn GREEN. Wait 5 to 10
seconds then start your vehicle
7) Remove the clips IMMEDIATELY after the vehicle has started. Black negative
clamp first.
8) DO NOT use the Vehicle Jump Starter to repeatedly try and start your vehicle.
Wait at least thirty (30) seconds between attempts. Check vehicle after three
attempts.
8