Ts 900 Beltpack Transmitter - Beyerdynamic Opus 900 Notice D'utilisation

3.

TS 900 Beltpack Transmitter

The TS 900 C beltpack transmitter provides charging contacts and can be powered by rechargeable
batteries as well.
3.1 Controls and Indicators
TS 900 C
4 3 2
10
AF input, 4-pin mini XLR for microphones (lavalier, neckworn mics).
1
For connection please refer to chapter 3.5 "AF Connection".
ON/OFF switch (ON = switch to "ON"-position; OFF = switch to "OFF" position).
2
Switch off the transmitter when not in use.
TS 900 C only: Battery status LED to indicate the power on / off and battery status.
3
(a) When the beltpack transmitter is switched on this LED will flash for a moment to
indicate the normal battery status.
(b) When the LED stays red after having switched on the transmitter the battery is to weak and
must be replaced.
Transmitting antenna
4
LC-Display
5
Infrared receiving diode for ACT function.
6
Gain control to adjust input gain.
7
GT/MT switch: When you use electric guitars this switch must be in the "GT" position.
8
In the GT mode the gain control is deactivated. Switch to the "MT" position when you
use condenser and wired microphones. In the MT mode the gain control is activated.
9
Battery compartment and cover for two 1.5 V batteries (AA).
10 TS 900 C only: Charging contacts
11 Removable belt clip can be rotated 360°. To remove use a screwdriver at a 45° angle.
1
5
6
7
11
8
9
69