How To Connect The Antennae - Beyerdynamic Opus 900 Notice D'utilisation

1.2

How to connect the Antennae

Connect the antennae to the TNC sockets
Please note that for diversity operation both antennae have to be connected. A weighting circuit
silently switches the signal with the better S/N ratio to the output.
1.3 Setting up
1. Place the diversity receiver in the same room or area as the transmitters. Make sure the diversity
receiver is placed as close as possible to the transmitter.
2. Do not place the diversity receiver near digitally controlled equipment.
3. Connect the AF-output to the corresponding input of the mixing console or amplifier.
4. Connect the receiver to AC power.
5. Switch on the receiver
6. If you use the receiver on a tabletop, please stick the supplied rubber pads to the bottom of the
receiver to ensure a sufficient ventilation.
1.4 LC-Display and Menu Settings
On the LC-Display all operating parameters such as RF and AF level will be shown. Using the "Menu"
control you can select from 6 options. The selected function is surrounded by a square frame and
7
shown at the bottom of the LC-Display.
By selecting the ESC button
previous setting.
To select the individual receiving channels of the NE 900 D / Q for entering the menu settings, press
the menu control
menu control to select the receiving channel. The green LED of the selected receiving channel will
flash. Press the menu control to confirm. The green LED will illuminate permanently.
The functions and operation are described in the following.
1.4.1 Diversity indication of the Receiving Channel
Each receiving module has two separate receiving circuits, one for each antenna. The signal with the
better S/N ratio is switched to the output. The received diversity channel is shown in the LC-display.
50
. The red LED will illuminate.
1
you can cancel the current entry into the menu to display the
8
until the green LED between the ACT and the SCAN button is flashing. Turn the
7
and ( . Set them at an angle (60°).
11 14