Klarstein Vinovilla 29 Built-In Duo Mode D'emploi page 31

CAUTION
Risk of injury! To avoid accidents while changing the door, we
recommend that you seek help. The glass door is heavy and can cause
injury in the event of a fall.
1 Place the unit in a place where you have enough space for the conversion and
open the door to the maximum angle. Remove the decorative nails (1) with a
small knife (2) and remove them (upper picture). Using the Allen screwdriver
(5), loosen the screws (4) on the fall protection device (3) and remove the fall
protection device (lower picture).
2 While a second person is holding the door, use the Allen screwdriver (5) to
unscrew the door spindle (6) at both ends of the door. Remove the door and set
it aside.
3 Loosen the screws on the upper suspension (7) and lower suspension (8) using
the Allen screwdriver (5).
4 Attach the lower suspension (8) to the top left and the upper suspension (7) to
the bottom left of the wine refrigerator.
5 Turn the door 180° and install the door on the other side of the wine
refrigerator.
6 Finally, attach the decorative nails (1) and fall protection device (3) on the
opposite side.
Note: If your wine refrigerator is equipped with a lock at the bottom of the door,
the door cannot be turned over, so you will need to order a right-opening door to
change the opening side.
EN
31