Heath Zenith 7396 Mode D'emploi page 2

2
A
ON
1 2
B
ON
1 2 3 4 5 6 7 8
1 2
C
ON
1 2
Figure 3
ON
A
1 2
ON
1 2
Push
Button
Setting
Figure 4
A
Helpful Videos – www.hzsupport.com
3. Determine push button type. Look inside
the push button and determine which type of
push button will be connected to the chime
(see Figure 3).
• Push Button < A > (2 Switches): The push
button has only two switches similar to the
chime.
• Push Button < B > (1 Jumper): The push
button has a single jumper.
• Push Button < C > (7 or 8 Jumpers or
Switches): The push button has a row of 7
or 8 jumpers or switches.
4. Sync the push button and chime.
Step A1 (see Figure 4)
• If push button switch 1 is set to OFF, ensure
chime switch 1 is set to OFF. Go to step A2.
• If push button switch 1 is set to ON, set
chime switch 1 to ON. Go to step 5.
ON
Step A2 (see Figure 5)
• Unplug chime. Wait 30 seconds.
1 2
• Press and hold the push button within 20
ON
seconds after plugging in the chime. Once
the "Ding-Dong" tone is played, the push
1 2
button is synced with the chime.
Chime
• Go to step 5.
Setting
0
30 Sec.
Figure 5
Syncing Push Button < A >
0
20 Sec.
Helpful Answers – 1-800-858-8501