Nordcap ROLL-IN 1P TN Notice D'installation, D'emploi Et D'entretien page 14

ACCESSORIES
The appliance can be fitted with the following accessories (on request):
- different voltages from the standard
- 100 mm wheel kit
POSITIONING
The appliances are designed for indoor installation.
- Check that the floor is capable of supporting the weight of the appliance
and that it is level.
- Respect the working spaces.
WORKING SPACES
The choice of the appliance's position is of fundamental importance for it
to work properly.
The appliances require a minimum space to operate and serving.
It must be installed as far as possible from any heat sources.
Ensure that there is a clearance of at least 50 cm. between the ceiling or
other overhead cover and the top of the appliance, to guarantee adequate
air circulation.
Note : The dimensions in the figure are expressed in mm.
Type 1 ROLL-IN 1P
ROLL-IN 1PP
DIMENSIONS
14
Operating space
Type 2 ROLL-IN 2P
ROLL-IN 2PP
Legend :
1 - Control panel
2 - Compressor group
3 - Power line inlet
4 - Self-evaporating drainpain
3
- Position of serial number data
Working space