Elpumps BT 4876 K Manuel Utilisateur page 19

Chapter 2: Application limits
WARNING! The pump is not suitable for pumping inflammable or dangerous liquids!
WARNING! Avoid dry operation of the pump strictly
Do not use the pump in garden lakes or swimming pools when persons, living animals are
staying in them!
Fibrous material may get into the pump's feeding chamber only because of the deficiencies of the collecting system or
careless sewage treatment, and they are to be removed from here in order to exclude any possible trouble occurring in
the operation of the pump! Establishment of a proper collecting system, careful discharge of the water and sewage (in
accordance with the regulations) and regular control of the pump are essential requirements. Equipped with automatic switch,
the pump can be used in continuous operating mode without supervision. When the water reaches the preset level, the level
switch will start up the device. The pump of small volume and weight will ensure delivery of the liquid with economical energy
consumption. The temperature of the delivered liquid shall not exceed 35°C, while the temperature of the environment 40°C!
DO NOT USE FOR
Cutting metals, hard plastics, etc.,
•
• Cutting fibrous materials (cotton, cloth, poly foam products),
• Delivering chemical, explosive or inflammable materials,
Delivering foods and drinks used for human eating,
•
Cutting food residues, bone, sour-cherry stone, etc
•
Chapter 3: Start-up, usage
DANGER! Risk of electric shock! Perform each operation of pump installation
only after having the mains cable disconnected.
DANGER! In order to avoid serious personal injury, it is strictly forbidden to
inspect the suction opening by hand while the pump is connected to the mains!
DANGER! Risk of electric shock! The person responsible for the installation must
ascertain of whether the electrical network is equipped with efficient earthing
cable in accordance with the current norms!
The pumps are single-phase devices, equipped with 2+earthed wall plug at the end of the
mains connection cables; in this case the earthing is achieved when the plug is connected to
the socket.
The device may be connected only to mains equipped with single-phase earth wire! Prior to the start-up, ascertain of whether
the mains voltage is the same as the nominal voltage indicated in the data plate of the device! The connection of the device to
the electrical mains network may be done only in a covered place, protected from rain. Select the place of connection in such
a way that it is easily accessible! For shock-proof protection, highly sensitive leak current protective
switch (Fi relay 30mA DIN VDE 01100T739) must be installed in the mains.
GB
19