Leveling The Washer - LG WM3850HA Serie Manuel Du Propriétaire

us_main.book.book Page 14 Tuesday, November 3, 2020 1:31 PM
14 INSTALLATION
29.5 - 96 "
(75 - 244 cm)
Using the Laundry Tub to Drain
1
Clip the end of the hose into the elbow
bracket.
• Connect the elbow bracket
inches (10 cm) of the end of the drain hose.
If the drain hose is extended more than 4
inches (10 cm) beyond the end of the elbow
bracket, mold or microorganisms could
spread to the inside of the washer.
2
Hang the end of the drain hose over the side
of the laundry tub.
3
Use the provided tie strap to secure the drain
hose in place.

Leveling the Washer

The drum of the washer spins at very high speeds.
To minimize vibration, noise, and unwanted
movement, the floor must be a solid, level surface.
29.5 - 96 "
(75 - 244 cm)
• Using the washer without leveling it may cause
• Adjust the leveling feet only as far as necessary
within 4
a
NOTE
• Before installing the washer, make sure that the
4 "
(10 cm)
How to Level the Washer
1
CAUTION
excess vibration and noise, leading to a washer
malfunction.
to level the washer. Extending the leveling feet
more than necessary can cause the washer to
vibrate.
floor is clean, dry and free of dust, dirt, water
and oil so the washer feet cannot slide easily.
Feet that move or slide on the floor can
contribute to excessive vibration and noise.
Position the washer in its final location.
• Take special care not to pinch, strain, or
crush the water and drain hoses. If you have
a carpenter's level , you can use it to
a
check that the washer is level. The slope
beneath the washer should not exceed 1
inch, and all 4 leveling feet must rest firmly
on the floor.