habitat et jardin Bineta Mode D'emploi page 14

Step 3:
A: Fix the Swing bar (6L) on the long axle of the Handlebar post (2) with Hex bolt (24),
Spring washer (52), Flat washer (25), Waveform washer (64) and Long axle (27) as
shown. Please do not tighten them this time.
B: Attach the connecting joint together with Pedal Support (5L) to the Crank (22) using
Pedal support bolt (38L), Waveform washer (62), Spring washer (41) and Nylon nut
(42L) as shown. Please do not tighten them this time.
C: Connect Swing bar (6L) with Pedal support (5L) using Hex bolt (30), Flat washer (31)
and Nylon nut (32). Tighten the Hex bolt (24) (30) and Nylon nut (42L). Finally Cover
the Nut caps (23) (57) (43).
D: Fix the Pedal support (5R) and Swing bar (6R) to Crank (22) and Handlebar post (2) in
the same way.
E: Fix the Pedal (10L/R) to the Pedal support (5L/R) with Hex bolt (33), Flat washer (34)
and Nylon nut (35).
- 13 -