DeWalt XR LI-ION DCB090 Traduction De La Notice D'instructions Originale page 54

EN G LI S H
TO REMOVE THE BATTERY PACK
Grasp battery pack firmly and pull from the DCB090 USB charging
battery adapter. Insert battery into the charger as described in the
charger section of this manual.
FUEL GAUGE
When the battery is inserted into the DCB090 USB power source, the
LED will flash briefly, then the number of lights will illuminate for ten
seconds based on the state of charge of the battery pack.
The fuel gauge (d) is an indication of approximate levels of charge
remaining in the battery pack according to the following indicators:
USB Charging Ports (Fig. 1)
The DCB090 USB charging battery adapter (b) is equipped with two
USB Type A charging ports (c). The DCB090 USB charging battery
adapter delivers 1.5 amps total current.
NOTE: Do not plug in devices that exceed the output ratings
on the charging battery adapter's label. Doing so will shorten the
charging battery adapter's useful life.
Insert a USB plug into one of the charging ports (c) to supply power or
charge your device.
MAINTENANCE
Your D WALT charger has been designed to operate over a long
E
period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper care and regular cleaning.
The USB charging battery adapter, charger and battery pack are not
serviceable. There are no serviceable parts inside.
52
75 –100% charged
50 – 75% charged
0 – 50% charged