Grease Filter - Elica Mini OM Guide D'utilisation, D'entretien Et D'installation

Maintenance
ATTENTION! Before
operation, isolate the hood from the electrical supply by
switching off at the connector and removing the connector
fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly internally and
externally.
Use a cloth moistened with a neutral liquid detergents.
Avoid abrasive detergents.
Warning:
Failure to carry out the basic cleaning recommendations of
the cooker hood and replacement of the filters may cause
fire risks.
Therefore, we recommend oserving these instructions.
FRONT DOOR
This should be left always closed.
To open:
The cooker hood should be cleaned regularly (at least with
the same frequency with which you carry out maintenance
of the fat filters) internally and externally. Clean using the
cloth dampened with neutral liquid detergent. Do not use
abrasive products. DO NOT USE ALCOHOL!
Warning:
Failure to carry out the basic cleaning recommendations of
the cooker hood and replacement of the filters may cause
fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage
to the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
performing any maintenance

Grease Filter

Traps cooking grease particles.
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
using hot water and a suitable detergent, or in a dish-
washer at 65° C (if the dish-washer is used, select the full
cycle function and leave dishes out).
Eliminate excess water without damaging the filter, then
remove the mattress located inside the plastic frame and put
it in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
Montage
Open the steam screen and remove the grease filter.
Install the carbon filter on the back of the grease filter and fix
with two rods.
Attention! The rods are included in the carbon filter packing
and not on the hood.
To dismantle the filter act in the reverse manner.
11
When