Summer 3D pac CS+ Manuel D'instructions page 15

5 Place the two car seat straps, attached to the stroller rails, into the Vehicle Belt
Hooks and across the car seat and lock the buckle. Slide the padded buckle guard
over the buckle.
Place the two car seat
straps, attached to the
stroller rails, into the
Vehicle Belt Hooks and
across the car seat and
lock the buckle. Slide
the padded buckle
guard over the buckle.
pull pull
tight! tight!
Vehicle
Belt
Hooks
WARNING
Avoid serious injury from falling or
sliding out. Always place the car seat
straps into the Vehicle Belt Hooks on the
car seat and raise the leg rest up until it
is in contact with the back of the car seat
in its locked in position.
• Clean minor stains on fabric with cold water and mild soap.
• Clean plastic and metal surfaces with a soft damp cloth. Air dry. Do not use
abrasive cleaners or solvents. Do not use bleach.
• Check seat pad harness and crotch straps weekly to ensure they are properly
secured to frame.
attaching a car seat:
care and maintenance
NOTE: Car seat straps and
protective covers can be
stored in the pockets on
side of the stroller.
15