Waeco AirCon Service ASC G Wi-Fi kit Notice D'utilisation page 6

Setting up the Wi-Fi kit
5.2.1 Setting Wi-Fi kit to Client Mode on the ASC
1. In the basic menu, use the cursor keys  or  to select
Other selections.
2. Press ENTER to confirm.
3. Use the cursor key  to select Wi-Fi kit.
4. Press ENTER to confirm.
5. Use the cursor key  to select Wi-Fi Setup.
6. Press ENTER to confirm.
7. Use the cursor key  to select Client.
8. Enter the SSID of the network you want to connect to.
9. Press ENTER to confirm.
10. Enter the password of the network you want to connect to.
✔ You can now connect your device to the ASC (see chapter "Connect-
ing to the ASC" on page 8).
NOTE
If you want to set the Wi-Fi kit back in Access Point Mode see chapter
"Setting Wi-Fi kit back to Access Point Mode" on page 7.
5.2.2 Setting Wi-Fi kit to Client Mode via web browser
1. Be sure that Wi-Fi kit is in Access Point Mode.
2. In the basic menu of the ASC, use the cursor keys  or  to select
Other selections.
3. Press ENTER to confirm.
4. Use the cursor key  to select Wi-Fi kit.
5. Press ENTER to confirm.
6. Select Show info.
✔ The ASC's display shows:
– The network SSID (ASC_UNIT)
– The password (administrator)
– The IP address of the user interface (e. g. 192.168.1.1)
7. If you use a device with an active SIM card (e. g. cell phone) enable
the "airplane mode" on your device.
8. Reactivate Wi-Fi on your device and connect to the SSID shown on
the ASC's display using the password displayed on the ASC.
9. Open a browser on your device (e. g. Google Chrome).
10. Enter the IP address shown on the ASC in the URL field of the
browser:
11. Go to Unit info and select Wi-Fi Setup.
6
ASC G Wi-Fi kit
EN