Publicité
Les langues disponibles
Les langues disponibles
EN
Wireless Operation
In optimal conditions, the WELL Fit can operate up to 300 m (900 ft) away from the W-DMX transmitter. The W-DMX
receiver in the WELL Fit must be paired with the W-DMX transmitter for wireless operation.
Initial Setup
1.
Turn the W-DMX transmitter on.
2.
Connect the W-DMX transmitter to a DMX controller.
3.
Place the WELL Fit within 300 m from the W-DMX transmitter.
4.
Turn the WELL Fit on.
Configuration
1.
From the WELL Fit's control panel, go to DMX Address.
2.
Select the start address, as with any other DMX compatible product.
3.
Go to Wireless Setting > Receive.
4.
Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5.
Press the reset button on the W-DMX transmitter. (The Signal Strength Indicator on the WELL Fit will show a
ϟ in front of the bars for 3 seconds while a connection is established.)
Product Pairing
If the WELL Fit has already been paired with the W-DMX transmitter, the Signal Strength Indicator in the middle of the
LCD screen will show the strength of the signal. In this case, the WELL Fit is ready to work in Wireless mode.
Pairing the WELL Fit and a new W-DMX transmitter.
1.
From the WELL Fit's control panel, go to Wireless Setting.
2.
Select Reset. The Signal Strength Indicator on the WELL Fit will show a ? in front of the bars.
3.
From the W-DMX transmitter, press <RESET> (the Signal Indicator on the transmitter will flash).
4.
Once the transmitter has found the WELL Fit, the Signal indicator on the W-DMX transmitter will illuminate solid.
5.
The Signal Strength Indicator in the middle of the LCD screen on the WELL Fit will show the strength of the
signal.
W-DMX operation can be interrupted or inhibited by liquid masses between the transmitter and
receiver such as water, snow, or people. For best results, keep the area between the transmitter
and receiver clear of any liquid mass.
3
QUICK REFERENCE GUIDE
WELL Fit QRG Rev. 6
Publicité
