Using The Lithium Packs; Use With Lenz Heat Products; Important Instructions For Use; Function Description - Lenz rcB 1200 Mode D'emploi

OPERATING INSTRUCTIONS / ENGLISH
discharge with the integrated electronics system.

USING THE LITHIUM PACKS

Use with Lenz heat products

￭ Remove the contact protector from the lithium packs (Fig. 1.4).
￭ Place the lithium packs in the intended position (see figure A,
B, C, D, E.).
￭ Press the lithium packs onto the snap fasteners until they
audibly snap into place (Fig. F).
￭ The lithium packs can be operated conveniently, either
manually through the visual control window or the textile
(Fig. G), or optionally via the Lenz heat app on a smartphone.

IMPORTANT INSTRUCTIONS FOR USE

￭ When using the heated product, the optimal heating power is
only produced when all heated products, textiles and socks you
are wearing are dry.
Do not operate the device at the highest heating power for
￭
longer than several minutes.
￭ Always set the product to a low or medium heat output to
maintain a comfortably warm temperature (the heater should be
virtually unnoticeable).
FUNCTIONAL DESCRIPTION

lithium pack rcB 1200 / lithium pack rcB 1800

Manual operation:
The lithium packs have 3 heating levels which are indicated by the
heat setting display (Fig. 1.2) on the lithium packs themselves.

Remote control:

When using remote control via the APP, the heat output can be
– 150 –
set to one of 9 levels via the corresponding controls in the APP.

USE AND FUNCTION

Turning on:
Turn on the product to the lowest heat setting by briefly pushing
the control button (approximately 0.5 seconds) on the lithium pack
(Fig. 1.3).
Setting the heat output:
This can be done by repeatedly pressing the function button on
the lithium pack (Fig. 1.3), or using the corresponding control in
the APP when using remote control.
The respective heat level is indicated by the illumination of the
heat setting display (Fig. 1.2) on the lithium pack, or in the APP
when using remote control.
LED, steady on – low heating power
LEDs, steady on – meduim heating power
LEDs, steady on – high heating power
Turning off:
Pressing the function button repeatedly turns the lithium pack off.
OFF
Note:
When using remote control, the APP must be closed to be able to
turn off the lithium pack. The lithium pack can still be turned on for
24 hours via the APP, but after that, only by pressing the button.
REMOTE CONTROL
The lithium packs rcB 1200 / lithium packs rcB 1800 can be
controlled via the Lenz heat app* for smartphones. The lithium
packs must be in "Pairing Mode" to be able to couple them
properly with the smartphone.
– 151 –