Display By Light-Emitting Diodes - Vogel KFG Instructions De Service

4.2 Display
by light-emitting diodes
LED LED is on = display mode
PAUSE
The operating voltage is applied at
h/lmp
the pump set and the control
device. The system is in the
PAUSE mode.
The operating voltage is applied at
CONTACT
min/lmp
the pump set and the control device.
The system is in the CONTACT
mode (pump motor is ON).
For system monitoring, a cycle
switch is used. Monitoring takes
CS
place at the progressively-acting
distributor while the pump is in
operation. (CONTACT)
Pressure switch monitoring is not
possible in progressively-acting
PS
distributor systems.
LED must not be ON.
The operating voltage is applied at the pump set and the control device. The control
FAULT
device is in the FAULT mode. The fault can be called via the LED display and be
visualized as error code after pressing the
The process of functions is stopped.
Page 23
Contents Chapter
4
Operating Instructions KFG, KFGS
LED is flashing = programming mode
The value for PAUSE can be altered.
The value for CONTACT can be altered.
This mode of monitoring can be switched
off in the programming mode.
COP = CS monitoring is active
COP = OFF
monitoring is switched off.
Monitoring by pressure switch must
not be activated in progressively-
acting systems.
COP = CS or COP = OFF
push button.