Philips SatinLux SC2000 Mode D'emploi page 19

Problem
The adapter becomes
warm during charging.
The charging light does
not go on when I put
the small plug in the
appliance socket.
I have switched on the
appliance but I cannot
increase or decrease the
light intensity.
The 'ready to flash' light
does not go on when I
place the appliance on
the skin.
Possible cause
This is normal.
You have not put the
adapter in the wall
socket.
The adapter is not
inserted properly into
the wall socket and/or
the small plug is not
inserted properly into
the appliance socket.
The appliance is
broken.
The appliance has to
be reset.
You have not put the
removable window
with safety ring
properly on the skin.
The safety ring is dirty.
Solution
No action required.
Insert the small plug into the appliance socket and
put the adapter in the wall socket.
Connect another appliance to the wall socket to
check if the wall socket is live.
If the appliance still does not charge, contact the
Consumer Care Centre in your country, your
Philips dealer or a Philips service centre.
Make sure the adapter is inserted properly into
the wall socket and/or the small plug is inserted
properly into the appliance socket.
Contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service
centre.
To reset the appliance, switch off the appliance
and then switch it on again. If you still cannot
adjust the light intensity, contact the Consumer
Care Centre in your country, your Philips dealer or
a Philips service centre.
Place the appliance perpendicularly onto the skin
in such a way that all contact switches touch the
skin. Then check if the 'ready to flash' light is on
and press the flash button.
If this does not work, place the appliance on a
part of your body where it is easy to establish full
skin contact, for example on your lower arm.Then
check if the 'ready to flash' light works. If the 'ready
to flash' light still does not go on when you place
the appliance on the skin, contact the Consumer
Care Centre in your country, your Philips dealer or
a Philips service centre.
Clean the safety ring carefully. If you are unable
to clean the safety ring properly, contact the
Consumer Care Centre in your country, your
Philips dealer or a Philips service centre to replace
the flash screen.
EngliSh
19