Remote Control Specifi Cations - Danby DPA080CB7WDB Instructions

•
Do not mix old and new batteries or batteries of different types.
•
Do not leave the batteries in the remote control if it is not going to be used for more than 2
months.
•
Dispose of the old batteries in special containers such as those found in the sales outlets.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected
4. Consult the dealer or an experienced radio/TV technician for help
Changes or modifi cations not approved by the party responsible for FCC compliance could void the
user's authority to operate the equipment.
This appliance complies with Part 15 of the FCC Rules. Operation is subject to the following condi-
tions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause unde-
sired operation.
This device complies with Canadian CAN ICES-3 (B) / NMB-3 (B)
Remote Control Specifi cations
Model
Rated Voltage
Signal Receiving Range
Environment
Note:
Temperature setting display: Press and hold the UP and DOWN buttons at the same time for 3
seconds to alternate the temperature display between °C and °F.
Performance Feature
1. Operating Mode: AUTO, COOL, DRY, and FAN.
2. Timer Setting Function in 24 hours.
3. Indoor Setting Temperature Range: 17°C~30°C (62°F~86°F).
4. Full Function of LCD (Liquid Crystal Display)
NOTE: All the illustrations in this manual are for explanatory purposes only. Your air conditioner may
be slightly different.
CAUTION
RG51I46/BGCE
3.0V (2-AAA)
8m
-5°C to 60°C (-41°F to 140°F)
3