FAAC KIT T-MODE Mode D'emploi page 17

3
WARNINGS: 1) THE T-MODE TELESCOPIC ROLLER KIT MUST BE ASSEMBLED ACCORDING TO THE "LT" LENGTH (Fig.3 or 5)
2) THE "LT" LENGTH IS ABOUT 4/6 cm LONGER THAN THE SIZE OF THE TELESCOPIC ROLLER TO BE ASSEMBLED.
3) WHEN THE ELECTRO-ROLLER IS BEING ASSEMBLED, THE PLATES (Fig.7 ref.A), INSTALLED ABOVE THE MOTOR AND
CAP SLEEVE (Fig.1 ref.
3.1 LT WIDTH BETWEEN 78 AND 100cm
For assemblies with an LT length (Fig.3-5) between 100 cm (maximum) and 78 cm (minimum), use the fixed roller (fig.1 ref. ) with the
motor sleeve inserted inside it (fig.1 ref. ).
To obtain the minimum value, using a saw suitable for iron, cut the telescopic roller to 73 cm. (fig.8)
To obtain maximum value, place the fixed roller up to the stop-point on the motor sleeve (Roller length 94 cm).
19
Motor sleeve fitted inside
the fixed roller
3.2 LT WIDTH BETWEEN 100 and 133 cm
For assemblies with an LT length (Fig.3-5) between 133 cm (maximum) and 100 cm (minimum), use the fixed roller (fig.1 ref.
the motor sleeve inserted inside it (fig.1 ref. ).
To obtain minimum value, place the fixed roller up to the stop-point on the motor sleeve. (Roller length 94 cm)
To obtain the maximum size, withdraw the fixed roller from the motor sleeve up to the safety limit marked on the plate. (Fig.9 ref.A)
(Roller length 127 cm)
19
Motor sleeve
WHEN YOU SLIDE THE MOTOR SLEEVE TOWARD THE OUTER END OF THE FIXED ROLLER, NEVER GO BEYOND THE SAFETY
LIMIT (Fig.9 ref.A)
ASSEMBLY OF THE TELESCOPIC ROLLER
- ) MUST SLIDE OUTSIDE THE FIXED ROLLER.
94 MAX
73 MIN.
67
127 MAX
94 MIN
67
Safety limit (A)
5
PLATE (A)
21
Max cutting
zone
Fixed roller
SLIDING
Fixed roller
Fig.7
Fig. 8
) with
Fig. 9