Silencer Housing Mounting For K05-Ts / K06-Ts; Using The 90° Manifold Kit Type Ck For K05-Ts - F.P.Z. SCL K-TS MOR Serie Instructions

4.2 SILENCER HOUSING MOUNTING FOR K05-TS / K06 TS
1. Identify the desired configuration (Fig.2, Fig.3, Fig.4).
2. Disassembly of the silencer housing:
2.1 Remove the #904 screws.
2.2 Take away the #700 silencer from the unit along with the
#424 gasket.
3. Disassembly of the #730 blind flange:
3.1 Remove the #909 screws, taking away the #730 flange
along with the #427 gasket.
3.2 Reassemble in reverse order-do not forget the #427 and
#424 gaskets.
4.2.1 USING THE 90°
(accessory) FOR K05-TS / K06-TS
The 90° manifold can only be installed on the #162 cover ports
and as shown in the Figures below, there are multiple
configurations.
The 90° manifold kit type CK comes supplied with;
1 x manifold
1 x #427 gasket and
4 x M8x25 UNI 5931 screws.
162
427
909
730
Fig.2 with 90° manifold
Fig.1
MANIFOLD KIT TYPE
424 904 706
90° manifold
Fig.2
To mount the 90° manifold, proceed as follows:
1. Disassembly of the #700 silencer housing and the #706
manifold:
1.1 Remove the #908 screws, taking away the #723 flange with
the #426 O-ring.
1.2 Remove #906 bolts, taking away the #700 silencer housing
with the #422 gasket.
1.3 Remove the #904 screws, taking away the #706 manifold
and the #424 gasket.
2. Disassemble of the #730 blind flange:
2.1 Remove the #909 screws, taking away the #730 flange
along with the #427 gasket.
CK
3. Mount the 90° manifold:
3.1 Place the #424 gasket between the #162 cover and the
#706 manifold and seal with the #904 screws.
3.2 Place the #427 gasket between the #706 manifold and the
90° manifold and seal with the M8x25 UNI 5931 screws.
3.3 Assemble the silencer housing in reverse order-do not
forget the #424 and #427 gaskets.
425
723
426
908
422 700 906
Fig.3 with two 90° manifolds
90° manifolds
Fig.3
GB - 20/48
Fig.4 with 90° manifold
90° manifold
Fig.4