Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TYPES OF INSTALLATION:
This beverage cooler has been designed for free-standing or built-in
must be adequate
Free-standing
A free-standing
desire You must follow the stated instruc
Built-in
A recessed installa on will allow you to install the beverage cooler under a counter or in a kitchen
cabinet provided the clearance space requirements around the beverage cooler are
necessary to allow adequate ven a on space around the unit (make sure there is at least some
room for the back of the
1 Place the beverage cooler in front of the
2 Adjust the feet and place the unit
requiremen
3 If the electrical outlet for the beverage cooler is behind the cabinet, plug in the beverage
4 Push the beverage cooler into
Warning: DO NOT install the beverage cooler behind a closed cabinet doo
Installa on Clearance Requirements:
When installing the beverage cooler under a counter, follow the recommended spacing dimensions shown
•
To ensure proper service access and ve
the
•
The installa on should allow the unit to be pulled forward for servicing, if necessary
•
A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with Na
and local codes and ordinances, is requi
•
A
1"- 2"
Important: Once you are ready to install the unit in a cabinet or directly on the oor, you must adjust the
feet to level the beverage
and access for service
will allow you to install the beverage cooler in almost any place you
s for electrical requirements and leveling the beverage
The following
on the
allow between 1 - 2 inches of clearance at the back as shown in
4
items must be observed:
or on a pl
depending on your
2-1/4"
Min.
In every case, there
It is
Electrical Code
Publicité
Table des Matières
