Positioning And Handling - MBM IN74T Manuel D'installation Et D'utilisation

Be fore proceeding with the ope-
rations, see "General safety infor-
mation".
OBLIGATIONS - PROHIBITIONS -
ADVICE
Upon receipt, open the machine
packaging and ensure that the
machine and accessories have
not been damaged during transporta-
tion. Where this is found to be the case,
notify the carrier immediately and do
not proceed with installation but con-
tact the qualified and authorised per-
sonnel. The manufacturer is not liable
for damage caused during transporta-
tion.
HANDLING SAFETY /
Failure to follow the instructions
reported below could result in
exposure to the risk of serious
injury.
The operator authorised for the
handling and installation opera-
tions of the appliance must pre-
pare, if necessary, a "safety plan" in
order to ensure the safety of the per-
sons involved in the operations. In ad-
dition, they must follow and strictly and
scrupulously implement the laws and
regulations relating to mobile sites.
Ensure that the lifting means
adopted have capacity that is
adequate for the loads to be lifted and
are in a good state of maintenance.
Perform the handling operations
using lifting means with a capa-
city appropriate to the weight of
the appliance increased by 20%.
Follow the directions on the
packaging and/or on the same
appliance before handling.
Check the centre of gravity of
the load before lifting the ap-
pliance.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.

POSITIONING AND HANDLING

Lift the appliance to a minimum
height from the ground in order
to ensure its handling.
Do not stand or pass under the
appliance during lifting and han-
dling.
HANDLING - TRANSPORTATION
/ - see SECT. IMAGES - REF. a).
The orientation of the packed
appliance must be maintained
according to the instructions
given by the pictograms and lette-
ring on the outer packaging.
Position the lifting means paying at-
1.
tention to the centre of gravity of the
load to be lifted (detail B-C).
Lift the appliance enough to move it.
2.
Place the appliance on the site cho-
3.
sen for final positioning.
STORAGE / The storage methods
of the materials must include pallets,
containers, conveyors, vehicles, tools
and lifting devices that are suitable
to prevent damage due to vibration,
impact, abrasion, corrosion, temper-
ature or other conditions that might
arise. The parts stored should be pe-
riodically checked to detect possible
deterioration.
DISPOSAL OF PACKAGING
Disposal of the packing materials
is the responsibility of the reci-
pient that should proceed in ac-
cordance with the laws in force in the
country of installation of the appliance.
1. Remove in sequence the upper and
lower corner protectors;
2. Remove the protective material used
for packaging;
3. Lift the appliance as necessary and
remove the pallet;
4. Place the appliance on the ground;
5. Remove the means used for lifting;
6. Clean the area of operations from all
the material removed;
- 8 -
3.