Transportation Requirements; Instructions For Use; Preparing The Appliance - Bosch PAM0520 Mode D'emploi

Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before turning it
back on again. This period of time is
required in order to ensure correct
appliance operation.
Avoid direct contact with the air expelled
through the expulsion tube.

Transportation requirements

The appliance is fitted with wheels to make it
easier to move around. If necessary, you can
tilt the appliance in order to move it. You
should not turn the appliance back on again
for a minimum period of one hour after
performing this procedure.

Preparing the appliance

Fitting the air expulsion tube and
accessories onto the appliance
Fit the air expulsion tube onto the fixture with
the "push" tab and thread it anti-clockwise,
Fig. 8.
Fig. 8
Housing for the air expulsion
Requirements for use

Instructions for Use

If easier, the housing can also be removed
from the appliance by pressing the "Push" tab
and sliding it out, Fig. 9.
Fig. 9
assembly
Once out, thread the expulsion tube as shown
on Fig. 10, making sure that it is properly
secured.
25
Before tilting it, empty the condensed water
from the internal tank by extracting the
water drainage pipe from its housing and
removing the plug, Fig. 7. Do not forget to
replace the plug and reinsert the pipe in its
housing when the tank is empty.
Fig. 7