BOMANN DB 616 CB Mode D'emploi Et Garantie page 48

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
5. The control lamp (2) lights up. As soon as it shuts off, the set temperature is reached.
Now you can start to iron.
NOTE: Always pull the plug out of the socket after using the iron.
Steam Ironing
Steam is produced by means of the steam jet function (3).
For steam ironing the tank must be full and a high temperature selected, e.g. cotton or
linen.
WARNING: The steam is hot. Danger of scalding!
NOTE:
If you would like to iron subsequently without steam again or at a lower temperature, the
water tank has to be emptied.
Refi lling the water tank
Always disconnect the mains plug before refi lling water.
Open the lid of the refi ll inlet (6) and carefully pour in the water. Do not exceed the
maximum line as marked on the water reservoir.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
GB
NOTE:
To avoid excess water leaking from the soleplate do not operate the steam burst for more
than 5 seconds without interruption.
Always remove the mains lead before cleaning!
Clean the casing with a slightly damp cloth.
Clean the iron with a slightly humid cloth.
Empty the water tank in order to prevent its contents from leaking.
CAUTION: The device must never be immersed in water!
48
05-DB 616 CB_neu 48
Cleaning and Storage
12.04.2007, 10:47:38 Uhr

Publicité

Table des Matières
loading

Table des Matières