Function - Jandy SFSM60 Manuel D'installation Et D'utilisation

|
Jandy Sand Filter SFSM Installation & Operation Manual
®
2.4.2 DiMenSionS
SFSM60 SFSM100
34" 41"
Dim "H"
(86.3 cm) (104.1 cm)"
26.0" 32.5"
Dim "D"
(66.0 cm) (82.6 cm)"
13.625" 16.5"
Dim "N"
(34.6 cm) (41.9 cm)"
21.12" 24"
Dim "M"
(53.6 cm) (61 cm)"
Dim
19.29" 24.6"
"B"
(49 cm) (62.5 cm)"
Weight
70 lbs 75 lbs
(empty)
(31.8 kg) (34.0 kg)"
Figure 1. Filter Dimensions

2.5 FUnCTion

Jandy high rate sand filters pass unfiltered (dirty) water through sand or sand over a shallow layer of pea gravel.
Water enters the filter at the inlet. Unfiltered water then passes through the diffuser(s) and moves down through the
filter medium. Larger particles are deposited at the sand bed surface and finer particles are captured in the spaces
between the sand grains. Filtered (clean) water then returns to the pool through the laterals.
Over time dirt and particles collected in the filter will make it more difficult for water to pass through, causing a rise in
the operating pressure of the filter. When this occurs it will be necessary to perform a backwash procedure.
Remember to fill the filter halfway with water before loading the filter media.
Diffuser
Backwash
Valve
Laterals
Figure 2. Filter and Backwash Function
During a backwash, water is routed into the outlet port
from the filter pump. The water then moves up through
the filter media stirring and dislodging particles and
debris. The backwashed water is forced back through
the diffusers and out the inlet port which will be routed
to waste drainage.
SFSM100F SFSM120
41" 47"
(104.1 cm) (119.4 cm)
32.5" 35.5"
(82.6 cm) (90.2 cm)
16.05" 18.75"
(40.7 cm) (47.3 cm)
23.77" 26.41"
(60.3 cm) (67 cm)
24.6" 27.75"
(62.5 cm) (70.5 cm)
80 lbs 143 lbs
(36.3 kg) (65 kg)
Filter
Free Board "F"
(See Section 3.3)
Fill to here
with water
Sand or
before adding
sand or gravel
Sand and
1"
Gravel
SFSM120F SFSM140 SFSM140F
47" 49.7"
(119.4 cm) (126.2 cm) (126.2 cm)
35.5" 37.5"
(90.2 cm) (95.3 cm) (95.3 cm)
18.6" 18.75"
(47 cm) (47.26 cm)
26.41" 26.41"
(67 cm) (67 cm)
27.75" 27.75"
(70.5 cm) (70.5 cm) (70.5 cm)
147 lbs 147 lbs
(67 kg) (67 kg)
Backwash
Valve
Use equipment only in a pool or spa installation.
Do not connect system to an unregulated city water
system or other external source of pressurized water
producing pressures greater than 35 PSI.
ENGLISH
D
3
2 4
1 5
0 6
49.7"
37.5"
18.6"
H
(47 cm)
26.41"
(67 cm)
27.75"
B
150 lbs
(68 kg)"
Backwash
WARNING
Page 5
M
N